오야이데 MTS-4e 4구 멀티텝

3274

오야이데 MTS-4e 4구 멀티텝입니다.

두텁고 견고한 알루미늄 절삭 최고급 샤시에 의한 방진과 정전기방지, 쉴드와 신호경로분리가 철저한 구조로 설계되었으며, 내부 배선은 4N 순은선 하드 와이어링, 아웃렛은 팔라듐 콘센트 SWD-XXXE 4구가 사용된 최고급사양의 멀티텝입니다.

신품입니다.
판매가는 송료포함 85만원입니다.
광주 직거래 가능하고 전국택배 가능합니다.

010-8615-1858
poohlover4364@hanmail.net

Dual-Spring vise structure for receptacles

The Dual-Spring vise structure is newly-developed for the contacts of our new outlet, SWD-XXX. Due to its strong holding power and 9mm wide contact area, the contacts tightly hold the inserted pins and reduce vibration at the contacts with no loss of signal transmission.

Chassis

The chassis of MTS-6e is made of highly rigid stainless steel which is non-magnetic SUS 304. It protects from not only vibration but also electric-magnetic wave or external noise contermination. And all components, from 6.0mm thick contact down to stainless screws, are made of non-magnetic substance.

Audio grade solder

For the soldering connection, we employed SS-47 audio grade solder.
Compared to general solders which usually contain 3N (99.9%) pure tin, SS-47 contains 4N (99.993%) pure tin achieved by excluding impurities to the maximum. Furthermore, 4.7% silver and 1.7% copper are contained for the purpose of improvement of electric conductivity and durability.

Inlet

The inlet is designed specially for MT series. The contacts are made of brass. The plating is a combination of silver (1.5μ) and rhodium (0.3μ). The body is made of 30%GF PBT.

Damping sheet

We adapted VEM 313 sheet (Visco Elastic Material) for damping material for the inside of the chassis.

internal wiring

For its internal wiring, we employed 2mm 4N OFC copper wire. And for its insulator, we employed low-dielectric polyorefin resin.

Brass spikes

For the better separation from the floor, we specially employed accurately machined brass spikes. Although it is set to four-point support as default, three point support is also applicable according to your preference.